faucet

Best Ways to Deal with Low Water Pressure in the Shower

By Brian, October 1, 2016

Nothing can beat a good shower in starting a good day. However, when you have to deal with low water pressure, you might experience frustration early in the morning.

Low water pressure can block the pipes. Not only that; if the problem is left unattended, it might escalate and cause water leaks. Luckily, there are several ways for you to quickly pump up your shower’s water pressure.

1. Adjust or remove the pressure regulator.

A water pressure regulator is a device that’s usually connected to the shower head. Most country’s government requires this device in order to regulate water flow and save energy and water. A pressure regulator only allows the shower to give less than 2.5 gallons of water in one minute. Since water flow is kept to a minimum, the shower sometimes delivers low pressure. You can always adjust the pressure regulator or remove it.

It’s easy to spot pressure regulators as they’re usually made of bright-colored plastics. Most manufacturers also always include instructions on how to remove them in the shower manual so you only have to follow it.

2. Buy a new shower head.

If you can’t seem to get the get the pressure regulator off your current shower head, buying a new one is your first choice. Go to a home improvement store near you and buy a cheap shower head. Why choose the cheap one? It’s because you only need it as a temporary replacement. Once you’ve bought it, take a drill and enlarge the holes. This works perfectly. However, it’s not a long-term solution.

If you want to have a permanent fix, it’s better if you callPlumber Sydney. Do not wait for water leaks. After all, professionals know best. Once you’ve contacted a plumber, it’ll help if you ask advice about what you should do when you experience the same situation in the future. That way, you will not have to fret the next time you go inside the shower and only get droplets of water.

3. Clean the pipes.

In some rare cases, low pressure is caused by galvanized pipes, which usually comes with age. When the pipe has been used for years, it can build up deposits that can restrict water flow. To fix this problem, drain water from the pipe first. Then, use a putty knife to scrape the rust and corrosion from the affected area. If you are not confident that you can do it, ask help from a professional.

4. Adjust pressure reducing valve.

Some houses install a pressure reducing valve on the main water supply line. This is used to regulate water flow inside the house. To adjust it, you need to loosen the lock nut and turn the adjustment screw clockwise to increase pressure and counterclockwise to decrease it. Once you’ve set it according to what you want, tighten the lock nut again.

Conclusion

Low water pressure in the shower should not ruin your day. There are easy fixes that can be done quickly. However, if you want the solution to last longer, you should ask for a professional plumber’s advice.

What do you think?

You must be logged in to post a comment.